The Electra Forums

Morning folks....I'd like to find one in this style for 335 size body. If you have one to sell, please send me a note with price. Thanks...

jd
eastern NC

borrowed pic

_________________
JD's Electras

I'd still like to have one of these guys....I still haven't been able to locate one. Keep an eye out for me.

_________________
JD's Electras

I will keep an eye out but I have never seen one in a catolog. E-bong may be your best bet. Good luck.

Its not quite the same design, but closest I have seen.

http://www.stewmac.com/shop/Bridges,_ta ... es#details

check the specs at the bottom of the page to see if its any where close to the right size.

http://www.stewmac.com/shop/Bridges,_ta ... cs#details

_________________
SlmGuy

Hey slmguy...I may have to piece one together. The one you sent links to is for the full body and the curlieque is on backwards. I could use one of those, but it would take a lot of modification work.

jd

_________________
JD's Electras

Sorry JD, heres the link to the thin one. Its just a plain trap but your right, you could take the curlieque off the deluxe and put it on the thin one.

http://www.stewmac.com/shop/Bridges,_ta ... es#details

You might be able to hook up with one of those guys at the local flea market that brazes everything to anything. You know, the guy with the special rod that does everything from hood orniments to pepsi cans. Snap-On dealers sell it to. Its called Quick Fix. Its in the RWD catalog, part#MTS1700. Its good for aluminum,copper,brass,zinc,die cast aluminum,pot metal, white metal and galvanized steel.

http://buy1.snapon.com/catalog/searchLN ... apon-store

I know, sounds like a lot of work to get a bridge..........

_________________
SlmGuy

I STILL haven't located one of these yet in chrome. I do have a gold plated early 70's one to swap for a chrome one.

_________________
JD's Electras